I need to make a list of things I'll need to take to an engine shop to get estimates so correct me if this is wrong. This is a complete list of everything I might need so tell me what's necessary/recommended.

Rods: magnaflux, shot peen, resize (do you resize the bottom or the top where the wrist pin goes through or both?)
Head: Magnaflux, resize valves to 1.94" and 1.6", would I need new valve guides? Could I port/polish myself?
Block: Magnaflux, Bore .060 over, Hone?, new cam bearings. alignment hone?
Crank: Magnaflux, Turned?

that means I'd need new bearings, pistons, rings, valves, valve guides? valves seats?, and the rest of the valvetrain.


69 Buick Special Deluxe. Intercooled Turbo Chevy 250 @ 15psi on a stock long block. It's kinda fast.