Inliners International Forums General Discussion Blown and Injected supercharged 250....carb setup

What recommendations for a Holley 500cfm 2bbl, mains & powervalve.?
61, PW 8,5?
Supercharged draw trough at approx. 5psi, 250 cid,Th350 trans, stock cam, 3,50:1 rear, Hei, with minor headwork on a Fleetline 50

I am running a inline 250, T3 turbo, blow-thru Holley 2300 350cfm, 10 psi max., HEI, AEM wideband to monitor

I drilled my pvcr's to .078", jets are at 61 and PV at 8.5.

If I had to do over again, Do Not drill out your pvcr's and jet accordingly. If your AFR's are too lean at WOT, drill them out a little bit.

Thanks!! I´m planning not to drill before checking the AFR..also have dual wideband checking!
Just nearly finished with the reworked intake, and bought the carb..and planning to buy some different jets/Pv on the same shipment!