I just got my reman 250 installed in my 1965 C20 pickup. I've got a couple of holley weber 2 barrel carbs that I would like to install one of on my engine instead of the rochester carb.
Does anybody have any idea of how to go about figuring the linkage out? All I seem to get done is get the primary barrel to engage but I cant seem to get into the secondary. as the linkage doesnt travel enough. Right now the linkage is connected to the pivot on the intake manifold. I'm not sure if I need to look at a cable system or not.

below is a couple of pics of the 2 different carbs linkage side. the side that faces the fire wall. I believe on is vega and the other a holley.

thanks mark

http://i942.photobucket.com/albums/ad263/bluecarpenter/IMG_0402.jpg

http://i942.photobucket.com/albums/ad263/bluecarpenter/IMG_0401.jpg

Last edited by bluecarpenter; 01/12/12 07:45 PM.