Hi guy,
I'm back to work on my stock head 302 Jimmy.
Most older posts were in a 2010 thread. I sure got some interesting ideas, and have been following up on them.
Hudson rods showed up. Pistons looking good.
Getting the crank drilled and tapped for extra bolts took a lot more convincing than I had hoped. (Limited choices for machine work).
Today I'm asking for more info on the stock 302 head. Ron G kindly posted flow figures for his #938 head and I have been talking to nearby flow bench specialists.
Most say they have little to no experience with the siamese port.
I would like to hear from anyone who has flow #s to share and porting experts to recommend.
Also, I'm looking for info on grinding each cam lobe on its own individual center (advanced or retarded according to the 3 potentially different port requirements) Reference = maybe Don Hendriks ?
I can't seem to pin down where I got this idea from.
Thanks in advance for any info
Regards, Wilbur
