OK guys, use your imigination and you can see the final intake! I was satisfied with the last cardboard mockup so I cut the aluminum to its dimensions. Once I measure everything again for the umph teenth time, I can lay out all the hole centers, drill/tap holes for studs, then have it welded up. Just for good measure, I'll add three nitrous bungs, centered inboard on the side under each plemun opening. I will also use water heat at the bottom. I hope it works.
I was satisfied with the last cardboard mockup so I cut the aluminum to its dimensions. Once I measure everything again for the umph teenth time, I can lay out all the hole centers, drill/tap holes for studs, then have it welded up. Just for good measure, I'll add three nitrous bungs, centered inboard on the side under each plemun opening. I will also use water heat at the bottom. I hope it works. 
