Originally Posted By: snowman4839
Ok so let's say I'm shooting for an 8.8:1 compression ratio.

And yes. Hank piston being milled where the chamber opens was exactly what I was talking about. That way it doesn't mess.with quench.

 Quote:
By ending up with .015" quench, that is all you need to do to get your compression where it needs to be.

I'm afraid I don't understand what you were trying to say. 0.015" is well under the recommended range you mentioned.



No, .015" deck on the quench sides + your gasket thickness will be your piston to head clearance(.040"-.060" recommended).



Class III CNC Machinist/Programmer