Originally Posted By: THE FRENCHTOWN FLYER
I would check the flatness and alignment of your manifolds and resurface as necessary.


thanks Tom and Frenchtown Flyer. I'll check the flatness with a straight-edge. My goal and intent is to just get on the road for now. I'm going to overhaul the engine this fall/winter, can't do it now. The nuts/bolts were not hardly torqued at all, they came off really easy. I'm crossing my fingers the new intake/exhaust combo is close enough...

Questions:

1) when I assemble the intake/exhaust manifold, should I use a gasket or just ring it with ATV?

2) On the new Offy intake, I need to put a vacuum port for power brakes in one of the holes. I plan to haul the intake into Napa to see if they have something. Any tips?

Thanks!
Mark

Mark
'67 Camaro L6-250