Yes Beater, it was here...I think as far back as 2003. The mount bolts to the motor mount holes (2) on the right side and to the starter holes under the rear of the block. I have a copy of the design. I tried to search but the search says it only goes back 10 years. Somewhere I have more info.
Scratch that...It was in the 12 Port News...Not on the forum!
AM Re: Engine stand adapter for inlines [Re: Beater of the Pack]
Drew, II # 4211 Offline
Active BB Member
****
Registered: 10 August, 2003
Posts: 1905
Loc: Glassboro,NJ,USA
Was Sneddon's mount the one that mounted on the side of the block near the center of gravity? It is a good system for a long block. Probably in 12PN if you can get a copy.
Answered my own question after checking back copy f 12PN. \:\) His article is in the Sept./Oct.2003 issue.
Last edited by Sam Welch; 10/03/19 08:57 PM.
