I have a '52 chev 2dr ht. The heater motor control switch is located on the "air" lever on the dash. Has anyone been able to use this switch when they converted to a 12V system? Al
You shouldn't have any problems with the original switch if it still is in good working order. 6 volt switches had to carry a much higher amperage than at 12 volts. I'm still using the original 6 volt headlight switch and dimmer switch in my 37 Chevy that has been converted to 12 volts for over 3 years.
Speaking of,I need to wire my 12 volt heater for the winter also. So with a heater switch, motor with 2 wires coming out of it and a fuse block, whats the best way to wire her up? THANKS THERE INLINERS.
Should use a relay instead of just wiring direct. Actually you should use two wired together.Give me your email add and I'll email you the schematics. Cheers!!!
1946 Chev Aerosedan Most southernest inliner in Canada