Inliners International Forums General Discussion Engines Piston Reccomondation or Rebuild kit

I am starting my first rebuild and would like to know if anyone could recommend a certain type of Piston or complete rebuild kit. Looks like they are all over the internet. Good experiences or bad let me know. I came across the Clifford Rebuild kit, just looked a bit pricey.

What engine are you looking to rebuild?
Stock rebuild?
Stock cam? etc..

MBHD

My bad,
The engine is a 250.
As far as stock rebuild goes, I am looking to get more performance out of the engine so I do not mind putting in some upgraded equipement, etc.

forged pistons are hard to find. i have a set out on ebay now. just clearing out some of the accumulation. cams can be had from almost any cam company. intakes, there is clifford or offy. tom

If you want forged pistons they are about $600 w/whatever compression you want. http://www.sissellsautomotive.com/pistons.html

Offy is a better all around intake manifold for the street.

307 cast flat tops w/4 valve reliefs for added compression, or use 250 pistons & install an early small chamber 194 CI head.

http://www.pawengineparts.com for standard rebuild of parts, gaskets, camshaft.

MBHD

forged pistons are not that hard to find or get. I just ordered a set for a 250 true flat top .030 over. File fit rings pistons & pin this piston with a 67 CC head will net 9.8-1 it will take about 3wks before i have them in my hands.

How much did those run you?
I think Tom was saying it is hard to find standard TRW forged 307 SBC pistons??

MBHD

Here is some 307 pistons
http://cgi.ebay.com/ebaymotors/ws/eBayIS...sid=e11010.m204


MBHD