Inliners International Forums General Discussion Engines Anyone here fabbed an intake?

I have a Miller 135 MIG welder, 30 percent duty cycle,120 volt, solid core wire with a tank. It can handle welding 14 guage stainless with either the steel wire(rusts) or stainless wire with athe proper gas mixture. But regular steel tubing is cheaper and so is a can of paint to dress it up.The thin stainless or common steel tubing may be hard to keep warm even with water heat, may have to insulate the tubing to contain the heat.Aquire a junk head to fab the manifold on to keep everthing in alignment.