I am changing out my manual front end for a power '84 C4 Corvette in the near (I hope) future. This means I will need to mount a power steering pump to an already crowded pulley system, including crank pulley, water pump pulley, A/C compressor pulley, and alternator pulley on my '73 250. The A/C unit sits above the distributor and the alternator sits low on the driver's side. Are you guys going to a vendor to buy your bracketts or are you fabricating them yourselves? In trying to think it out, could one run a belt from the alternator (with a two groove pulley) to only the p/s pump? "A picture is worth a thousand words." Thanks in advance.
