When you buy your rebuild kit also buy enough carb cleaner to soak the carb parts clean. There can be a large amount of fuel gum built up inside
the carb. You really only need 3 tools to strip a
Rochester;Phillips head & flat blade screw drivers
and needle nose pliers.The kit instructions are usually very clear. Lay out the parts in order of disassembly on a tray so small parts don't get lost and match the new parts to the old. You'll likely have extras as most kits do several variations of the same carb. You also will have a small L-shaped paper ruler in the kit to adjust the float levels. Do this as carefully as you can. It's important.Follow the schematic and take your time. It's really not hard at all.
