I had my 292 (.60 over) dyno'd when we picked it up from Mike Kirby at Sissell's Automotive. We haven't finished the installation in the car (truck - 1950) but hope to have in ready to roll for this summer. It has been over a year since we had it run on the dyno so I don't remember the exact numbers and at the moment am too lazy to go dig out the paperwork. The engine has one of Mike's 12 port aluminum heads, 12 to 1 compression and Hilborn mechanical fuel injection. On race gas we got around 465hp (about 6800rpm, I think) and a little over 400 ft/lbs of torque. We did better on alcohol but Mike didn't have time to really play with it. He felt with enough time (and good air) he should be able to get 475 on gas and just over 500 on alcohol. The truck will be used for nostalgia drags with a good old fashioned 4 speed (Jerico, so it will be up to the abuse). It should be fun!
