First of all you need to make sure you have enough clear on to be able to cut and polish so as you do not cut through the clear. Stay away from sharp corners. You can put some tape on the areas to stay away from. I lay 3 wet coats down and then let sit for a couple of days. I'll then sand down with 800 to 1000 dry on a 6" palm sander with an interface pad. Let it sit out in the sun to make sure its done gasing and bring back in an lay 2 more coats on. The next day I will hit with 1500 slightly wet and then 2000 wet mirka abralon 6" disc and then 4000 mirka abralon disk, wet. Only doing about a 2x2 area at a time. Then I finish it off with Presta 2000 polish with a blue foam pad. Start off with about 1000 -1200 rpm till you get the hang of it.I would suggest you get an old hood or panel and clear it and practise on the old hood first till you get the hang of it. It's a great way to learn. But do not buff over 2400 RPM or you will be repainting your ride. Good luck.


1946 Chev Aerosedan
Most southernest inliner in Canada