CNC Dude, " It is possible that with the 6" H-beam rods that are available for the 250 today,that the LS piston shown could be made to work with a little block decking to adjust the deck height",,
So w/a 6" rod,,it should work,correct?
Thanks.
Ross forged 250 pistons are $450 for a set of 6 w/rings & pins?
If so, great price!!
MBHD
Hey MDHD, just doing the math, you end up with about -.060 deck clearance(with the LS piston shown and a 6" rod), another post last week, a guy was asking if .040 was too much to deck off a 250, so if you feel that is safe(I think it would be), then that would be a pretty neat rotating assembly for not a lot of money. I also forgot about the Ross pistons including the rings with them to, so that is a pretty sweet deal considering....The H-beam rods are about $350 bucks if I am remembering correctly. Surely it wouldn't be hard to find (5)guys wanting to jump in and get some Ross' pistons to meet the engine builder price requirement.....or 292's or GMC's and 235's for that matter.
