Hi,
I'm looking for some help with my gas gauge. What I have is a 12 volt gague in my 54 pick up. The truck was converted to 12 volts from day one that I started driving this truck. I even tried putting the original 6 volt gague in with a resister with no response. The problem is that not getting any reading out of it. it use to work, I have a new sending unit at least a couple years old. I have the hot line from the ignition switch and wire to the sending unit. What I get is the needle goes all the way to full and the gague gets warm. I tried to hook the line from the ignition switch to a hot wire to the junction box and there is no reading needle stays on E. I put a ground wire from the bell housing to the frame of the truck no change. I have pulled the sending unit and at least it is intact and looks good. Any help or suggestion for things to look at. I don't like not having a working gague.
Thanks in advance for any help Steve
