Inliners International Forums General Discussion Engines My 235/Computer Idiot

Here's an older pic of my 235 that's now sitting
in my'55's frame.I just wanted to fiqure out this URL stuff to post a pic so you all are my giunea pigs for my test.

http://pic19.picturetrail.com/VOL1061/3611363/7434004/97148906.jpg

Looks good! Is that an offy intake with Fentons? Did they bolt up ok or did you have grinding to do?

Yes, It's an Offy/Fenton combo. No I really didn't have any issues with grinding although I may later as one clamp sits at an angle, not parallel to the head and may loosen which means I'll have to grind a flange on the Offy. I did have to grind out the exhaust end of one Fenton
to get the "O" ring seal between it and the J pipe to seat properly.

Very nice. Is that a Harbor Freight engine stand?

CD;

Yes; good job.

The stand is from the Home Depot (lumber Dept) perhaps.

JM.....

Hey,thanks guys for the compliments.JHM is the winner of the next 10% off HD coupon I get!
Actually the stuff is scrap from my neighbor's
$10,000(!) deck! Yes,10K.And they hardly use it. :rolleyes: I'll try to post an update of the 235 in my chassis with trans/driveline,etc. It does look sweet sitting there now. And it runs like a champ.