|
|
Joined: Mar 2004
Posts: 757
Major Contributor
|
OP
Major Contributor
Joined: Mar 2004
Posts: 757 |
Here is one for all you aluminum Powerglide gurus. After digging around for the cable gear all I seem to come up with is a range from 22 to 25 teeth on the driven gear. Does anyone know if others were / are available? Specifically a 20 tooth gear.
These are .080" larger in OD than the more common late Muncie / Saginaw / TH350 gears, but not as large as the 700R4 and others from GM.
Mike G #4355
|
|
|
|
Joined: Sep 2000
Posts: 588
Major Contributor
|
Major Contributor
Joined: Sep 2000
Posts: 588 |
Mike, GM only used two sizes of gears. The P/G and std trans used one series then went from 17T upto 24T and the older TH400 and newer 700R4 used gears with teeth from 37T upto 44T. I have some of the smaller ones if I can help you out. Do you need it before the Jack Halton Run ?
Ontario Inliners 1965 Chevelle 1940 Chev 1965 Chev Pick-up 1970 MGB Roadster
|
|
|
|
Joined: Mar 2004
Posts: 757
Major Contributor
|
OP
Major Contributor
Joined: Mar 2004
Posts: 757 |
Don, I too thought that was as simple as it was. Turns out that there were 2 different diameter drive gears on the tailshafts. Alum glides, original T-10, and some of the early Muncies had a 1.760 diameter steel gear on the tailshaft. With the intro of the TH350 their drive gear diameter went to 1.840 and was made of nylon. They went to the 1.840 in the Muncies too but kept it as a steel pressed on gear for a while but eventually changed it to the nylon gear of the same diameter. This all took place about 1969 or 1970 after the Powerglide was history. Since then all the TH350, Muncie 3 & 4 speeds, and the Saginaw 3 & 4 speeds all used the same drive and driven gears, leaving the aluminum glide and the early Muncie 4 speeds unique with the small 1.760 steel driver that requires the larger diameter driven gear. The more common 17 to 24 tooth smaller driven gear for the 1.840 driver won't work in these.
Nobody was more surprised than me when I discovered there were 2 different speedo gear diameters for 4 speed Munices!!! It must have been a cost cutting / inventory measure to use the same parts as the Powergilde in the early Muncies. Worked real good - look where GM is at today. LOL
Mike G #4355
|
|
|
|
Joined: Dec 2000
Posts: 3,332
1000 Post Club
|
1000 Post Club
Joined: Dec 2000
Posts: 3,332 |
M; Ask "Gordy250", he's the Powerglide expert here.
John M., I.I. #3370
"There are no shortcuts to any place worth going". -Anon
|
|
|
|
Joined: Dec 2000
Posts: 3,332
1000 Post Club
|
1000 Post Club
Joined: Dec 2000
Posts: 3,332 |
M; Ask "Gordy250", he's the Powerglide expert here.
John M., I.I. #3370
"There are no shortcuts to any place worth going". -Anon
|
|
|
0 members (),
35
guests, and
29
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|