Inliners International Forums General Discussion Hi Performance Need help with linkage???

I have an Edmunds 216 2x1 intake with the solid mount linkage that goes through the carb towers.Heres my problem,it(linkage)was complete but bent and mismatched.I have already got some 5/16 stainless rod.I have the 3 arms,one is cast alunminum with set screws,another is home made with a 3/8 nut and 1/4 inch plate and the other is brass but to short.I need them all matching and heres what I need:
the over all lengnth of the arm 3 inches
it needs to have a 5/16 hole on one end and a 1/4 hole on the other.The spread on the holes need to be roughly 2 3/8 to 2 1/2 on center.

Does anybody know where I can get them?I have been trying to call vintage speed for 3 weeks and there is never any answer.I have emailed them with no response.

Someone please point me in the right direction.Thanks in advance!

Ratatatat
I send you a Private message In regauds to your needs Let me know if i can help.

go to the MOPAR thread on "flaty is running". there is a really nice looking linkage set up that might help.