|
|
Joined: Feb 2006
Posts: 3
Newcomer
|
OP
Newcomer
Joined: Feb 2006
Posts: 3 |
working on a 292 for a friend comppresion,spark,air,and timing are all good but 1 and 2 won't ignigte the only thing i do not know forsure is fuel but the plugs in 1 and 2 are dry. the two cylinders ere not firing i think the plugs would be wet.
|
|
|
|
Joined: Apr 2002
Posts: 306
Contributor
|
Contributor
Joined: Apr 2002
Posts: 306 |
With a test light check for voltage from battery through ign switch etc, also timing, plug wires etc. If all else fails review basic tune up specs, valves, compressions, fuel pump. Clogged fuel filter????? Good luck
Jim, I.I. #173 (It's easier to get forgiveness than permission!)
|
|
|
|
Joined: Feb 2006
Posts: 3
Newcomer
|
OP
Newcomer
Joined: Feb 2006
Posts: 3 |
the engine starts fine when i pull #1 or#2 plug whires whith the engine running it doesn't change anything. if i pull one of the other plug whires you can definately tell a difference.i have checked spark at the wire it's good. true the plug it's good, compression,valves,firing order,timing everything checks out. the only thing i can't tell for sure is if any fuel is getting from the carb to the #!,#2 intake port.i even pressurised the cylinders whith the intake valves open to make sure air was flowing it is.
|
|
|
|
Joined: Jan 2006
Posts: 16
Active BB Member
|
Active BB Member
Joined: Jan 2006
Posts: 16 |
could be bad spark plug...even if new,,i've got bad ones before..put a new set in once, truck wouldn't run, they had spark..that was the only thing i changed so took em back got another set, it fired right up..
|
|
|
|
Joined: Oct 2004
Posts: 204
Contributor
|
Contributor
Joined: Oct 2004
Posts: 204 |
Check to see if the valve lift on one and two is the same as the other valves, worn lobes? A head gasket problem between one and two, maybe?
|
|
|
|
Joined: Jul 2004
Posts: 153 Likes: 4
Contributor
|
Contributor
Joined: Jul 2004
Posts: 153 Likes: 4 |
B,I had a problem with a 230. Cylinders 1-4 ran but not 5 & 6 . Turned out to be a bad intake manifold to head gasket or manifold bolts not tight.
|
|
|
|
Joined: Feb 2006
Posts: 3
Newcomer
|
OP
Newcomer
Joined: Feb 2006
Posts: 3 |
thank you for all your input. still confident in everything except fuel getting to 1&2 today i removed the intake looked pretty wet so i shined a flashlight into the intake thru 1&2 and discoverd a 6" crack on the bottom outside corner,and the bottom inside corner of 1&2. not sure if this is the problem but i removed the intake and dropped it off at one the original dirt trackers,and now waiting for his mojo to dry. let you all now what happens hope i don't need a intake.
|
|
|
0 members (),
383
guests, and
16
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|