Inliners International Forums General Discussion Engines blocks to heads

new to board so would like to say thanks for any help.ok im getting a 250 block from a friend that needs some help.i also have a 194 complete.will the 194 head fit on a 250 block?i believe the 194 came out of a 64 nova wagon.im going to put a 250 in my 51 chevy sedan.or should i put the 194 in?hows the power from a 194 compare to a 250?thanks for the help.
jason

Dear Jason;

I would look for a 261". It's a 'bolt in' so you save all that conversion etc. Can be built to almost 300cid too.

Good luck, John M., #3370

------------------

Jason
The 250s came stock with 145-155 hp.The 194 for head would up the compression on the 250 block to about 10-1 or more depending on the piston used. Hope this helps. for your plans.
}[oooooo]



------------------
NovaMan/Twisted6/Larry

jason,

first, the 194 was rated at 120 hp. second, if you do go ahead with the engine swap and plan to build the 250, check the 194's exhaust ports. early 194s had siamesed exhaust ports which don't exactly make for the best exhaust flow, and can be a bit of an issue with headers. if the 194 head does have siamesed exhaust, you may be better off milling the 250 head for higher comp.