Inliners International Forums General Discussion Ford HOLLEY 500 CFM 2V BASE PLATES

Where could a poor drag racer, desperately trying to get his car in the eights, find some Holley 500 CFM two barrel carb base plates? The butterflies measure 1 11/16". Thanks for your help.

Greg Koesel
734-242-1266

French No Luck with Holley Or you like the most of Us lol have to keep The Low profile Out look
and How many do you Need Or want?

M# 3220 }[oooooo]

I've got one - need two more. I have other 300 six parts and Ford V8 engine parts to trade also.

French
I'll look and see if i still have any extra's here.I know i had two or three But i gave a Bunch of carb parts away not to long ago.I will look over the weekend and get back to you.ALL YOU Need is The Plates Right??

#3220 }[oooooo]

Hi Guys, ...if you get stuck there are a few eBay sellers with circle track Holley and Rochester 350/500's and intake plates. Sorry I forget their names.
Bob 4140

Twisted, Yes , I just need the 500 base plates (With the throttle blades and shaft of course) that I am going to marry to the 350 main body (venturis). Thanks for checking everyone.

Sorry French I don't have any Left. But I will keep my Eyes Open for some. Good Used Or Rebuildable plates.

# 3220 }[oooooo]

I have acquired all I need now, plus three to convert to alcohol if needed. Thank you all.

Well the 350/500 combo ran slower than the 500s. Oh well, I never would have guessed that it would have been undercarbureted with the three 350s (750 cfm 4V equivalent) but it is.

Next project - (3) 500s on alky.

Surprize ?? why were you running all 500s before??(3x500) and thought you had to much?? that you went to all 350s.

It would sometimes lose signal when I stabbed it and it was cold out. Then it would stumble a bit before recovering. Now I'm sorry I sold my three 650 2V's. They would probably work well with alky.

Yes they would have and probley wouldn't have had to up size the Jets for the alky for the size.?? But thanks French