Inliners International Forums General Discussion Hi Performance Langdon's Cast Headers for 250 Chevy

I have searched but cannot find a reference to the required diameter of the headpipes that first exit each header outlet flange. I planned on using 2" and having a muffler shop flare the end to fit the packing that I got with the headers. Sound right?

My Langdon headers came with a flange for the pipe and if I remember it was a 2 1/2 inch hole. I made a tapered head pipe to reduce to 2 inches. S

This is 2 1/2" to 2" pipes with a 250 in a 63 Nova belonging to Strummin 67 http://groups.yahoo.com/group/GM_Inline_...ount=20&dir=asc

I have my exhaust installed. It went very well, I used a Summit 2.25" dual system that I got on sale for $135.00. It installed and cleared everything easy. I used 2.25" mandrel bent tubing to construct the pipes from the Langdon's split headers to the Summit exhaust pipes. A lot of cutting, fitting and welding, but a good result.

Follow the photobucket link for pictures of my project.

Looks good!!!!

Of course we need a video w/sound.



MBHD

Yes, sound please.

Looks very nice.

I am several weeks away from first start. What are people using to take video? I have a Kodak Digital camera. Will that do the job?

i use a digital camera. works great!

Clean install bigmike. Looks good.

Can you turn the clamps sideways so the u-bolt ends don't hang low?

Those were temporary. All replaced with stainless steel band clamps from Walker now. The flange on those is rotated up out of sight. Must keep up appearances.

mike
if you're putting tom's headers in an AD e/w a stock steering box::
Tom will have to cut and reweld the exh. flanges @ 90 degrees as they will not fit a truck w/ a stock steering box and clutch arm actuation.
http://s67.photobucket.com/albums/h298/1951otter/?action=view¤t=8A-2.jpg
http://s67.photobucket.com/albums/h298/1951otter/?action=view¤t=7A-2.jpg
http://s67.photobucket.com/albums/h298/1951otter/?action=view¤t=5A-1.jpg
http://s67.photobucket.com/albums/h298/1951otter/?action=view¤t=3A-2.jpg
http://s67.photobucket.com/albums/h298/1951otter/?action=view¤t=6A-1.jpg

Tom knows about this

Getting closer to first start on my inliner project. Thanks to all that posted, there is a lot of good information there. I am doing all the small things that didn't seem to make it to my "do list". Eats up time. I hope to get to the point where I can start it up by mid October. Stay tuned.