Inliners International Forums General Discussion Hi Performance Crank pulley

i need a crank pulley for my 250 but i have a fluid dampener can i use the stock pulley and just weld the 2 pieces together. i have heard that a set off a small bolck with a short water pumps would work. Does any one have any ideas? Thanks

Dear Chevy Guy;

Check with Hank or Larry in the
High Performance section.

Good luck.

Yes, you can bolt on any combo of SBC pulleys. The short WP versions work best. They came in singles, doubles and triples. You can also shim it with flat washers if needed for allignment. Tom