Like to offer my CNC design and milling service up to my fellow inliners.
We start with your sketch, turn it into a computer drawing and then send it to you to check. Then if all is good we cut the part and ship it off to you.
Very reasonable rates for this type of service.
51 GMC 4.2 turbo Can't solved today's problems using the same technology/thinking that created them
yes - in 2D - the side profile should be finished on a lathe. Most 3D work is ok - can't do 3D compound curves - not yet anyway - controls a bit too old.
Last edited by efi-diy; 02/18/1205:52 AM.
51 GMC 4.2 turbo Can't solved today's problems using the same technology/thinking that created them