Inliners International Forums General Discussion Engines Inline 6 power steering

Does anyone know where I could buy the mounting brackets?

Depends on what engine?

I'll sell you this entire front end drive assembly - alternator, P/S, AC, etc. - less the damper for $150 firm.

If your going the non traditional route such as a street rod you can get the Davis Speed brackets like this.

ORIGINAL 250 P/S STUFF IS VERY EXPENSIVE AND VERY HARD TO FIND AND A/C STUFF IS EVEN HIGHER AND HARDER TO FIND... THEY DIDNT MAKE ALOT OF THIS AS THE 250 WAS ENTRY LEVEL ENGINES. AFTERMARKET OR MAKE YOUR OWN IS THE WAY TO GO. JMO

1972 chevy 250

I didn't think you could get AC for that.

Go and read this thread : https://www.inliners.org/ubbthreads/ubbth...ed86416424495db

I saw that, and if I can't find one that is close to original, I will buy his.

If you want Ac try these brackets

Eh AC is too much or a pain to install, plus I never use it in Colorado

ITS EASY TO MAKE THESE BRACKETS IF YOU HAVE A ENGINE ON A STAND WHERE YOU CAN GET TO IT EASY. THAT CLIFFORD ALUM TIMMING COVER IS NEAT. NEVER SEEN ONE OF THEM BEFORE. WHERE DID YOU GET IT STANZ
BOB

That's not my motor, its just a pic i found surfin the net. I think Clifford stopped making those covers since I don't see them listed on their site. I have heard they might start making them again. lets hope so, I want one!