I just got my 261 back from the machine shop and when my new parts come in from Patrick's, I'll be bolting it back together. Problem is I do not have an engine manual for the 261, so I do not know the various torque specs I will need. I would need specs for: mains, rods, head, intake and exhaust manifolds, timing cover, oil pan, valve cover, water pump, thermostat housing, flywheel, bell-housing to block, trany to bell-housing, pressure plate, motor mounts, starter. Did I forget any? Does any one know if there is a source for new head, main, and rod bolts for my 261? I'd heard that you should always replace them on a rebuild. I also read that if you have the head decked that you need to shim the head bolts by an equal amount with washers. Is this true?
