"Most '3-pot' systems only idle on the center Carb., with the mixture screws all the way in to seal the fuel ports."


Thanks Guys. So should I turn in the idle screw on the two outside carbs and only set the idle on the center one? Then, if I set the linkage up in progression will that work nearly the same as the stock single carb setup at lower speeds when the outside two carbs haven't kicked in yet? I'm trying to get the both of best worlds here (economy and performance) I'm even running a 3-Speed w/overdrive.

"All too often the difference between success and failure is doing something right and doing something nearly right."