Speartech did my harness for $450.00. Did a real nice job.
The first article on my truck is going to be published in the next issue of "Military Vehicles Magazine"
This series of articles features step by step upgrades on a 1953 Dodge M-37. The first covers the simple task of installing locking hubs. Each issue will upgrade the truck further until it's ready for the 4200 Re-power.
I know you folks here would like to get right to the engine, but I had to sequence this in a way that could be reproduced by the reader, & be safe to drive.
Sequence will pretty much go as follows:
Hubs
Master Cylinder
Disc brakes
Radial Tires
Final drive gears
Centered rear-end
Engine and trans install
Engine wiring and fuel system
The editor may chose to double up some of the upgrades, (ie. Master cyl. and disc brakes).
So, please be patient. Were almost there!
