I'm having some trouble getting the envoy to start. It was a rollover, so I figured part of the cranking problem might be oil in the cylinders. so, I pulled all the plugs out and cranked it over a few times. wow, it coated much of the front end with oil. so, I figure all is well and I reassemble it. Upon doing so, the same thing happens. it turns over for a while and then stops. it is very difficult to turn over with a ratchet at this point. I have to say, I'm a little worried that something seriously bad has happened... any ideas?
ataac_flat04 - I bet I am, but I sure hope I'm not still working on getting this thing running by the time they finish that
I'm not exactly patient
