Hey OHCFbird,
What have you done to address the issue of the Cam Phaser if you're running an aftermarket controller ? If the phaser is not used does it stay advanced or retarded. I seem to recall from some of my reading that there's about a 24 degree range in the unit. Will it "Stay put" if not used or do you have to do something to mechanically make it stay in one position. I don't think it would be good to have it "floating' even a few degrees uncontrolled.
I got bit by the 4200 bug myself and ditched my 292 project for now. I'll get back to that project later for another vehicle.
I'm not sure I'm following some of the earlier info so maybe you (or someone) can clarify for me:
Does Westers or anyone else have a modifeid ECM or aftermarket ECM that allows the use of the Cam Phaser ? It's one of the features of this motor that makes it such a powerhouse I'd hate to eliminate it unless I absolutly have to.
Thanks,
