Hey guys, new here, thought I could use some of your expertise.
We are about to start building our first bonneville car. The engine will be a 250 with a single turbo.
Very little details have been set, as one can affect the other, still trying to figure out what we need.
The block will be a 250 with a max overbore of .030"
Plan on using 6.00" small block small journal rods with cap screws to help with clearance.
Pistons will have to be custom made, most likely JE or Aries.
Looking for 9:1 compression
O ringed block
Head will be a lump port, plan to use beehive springs, and Comp Pro magnum bbc rockers.
Cam will be flat tappet solid most likely from Comp Specs unknown at this time
Intake will be a clifford single four
Barry Grant demon blow through carb
Turbo size is unkown at this time Looking for 10-15 lbs boost
The goal is a power peak around 5500 to 6000 rpm
Car will run on 110 race gas.
Any tips would be greatly appreciated. I have Leo Santucci's book, and have read it several times.
Have Corky Bells Maximum Boost on the way.
We are used to building 1/8th mile big block drag cars, so this is quite a change for us.
