I have a 235 with a Rochester B carb that I'm trying to retrofit with PCV instead of the road draft tube.
I tried a Fram FV184 PCV valve because it's for the Chevy 194/250.
I'm using 3/8 rubber hose from the valve to the fitting on the intake manifold
It seems as though the model B carb can't provide enough fuel through the idle jet to support the extra air coming in through the PCV valve. I've got it almost all the way out and it still runs rough as if it were lean. Any comments? Do you think I should restrict the flow through the PCV some?
Anybody done this successfully on a similar engine/carb combo?
regards,
Leon
