Larry, thanks!
But I didn't understand. I installed your bolt-in lumps in the bottom of the head ports (they look perfect and it was really bolt-in)
.
So I am asking about the top of the head port lumps. The top of the ports were milled a bit making it flatter. So I install a lump there? It would decrease the intake port volume. I believe this is good if it also has a shape as well as the lumps installed in the bottom. Or not good?
Anyway... Do you have this upper lumps so I can buy again from you? Or they are simple and I can make it?
I am thinking that if I make lumps straight it will reach the valve guide area. Sorry, I am a lot confused.
Also I am not using port dividers and won't use it.
My engine is going good and hope to finish it this year. It is a Chevy 250 normally aspirated for street/strip use.
Thanks a lot!!!
Alex
