I'm confused Larry. I thought that going to a 'smaller' rocker would decrease lift. Obviously it won't change duration much. The motor originally came to me with BB lifters but some of them were 'wallowed' out in the pushrod area. I bought some SB 1.5 lifters thinking that would make the big cam effect less severe. I do not know the specs on the cam other than it was supposed to be .600 lift. I measured 3.3X on the cam lobe with a dial guage (think that was what it was..I posted it on the site but all the old messages seem to be gone.)
If it's not obvious, I'm not a master engine builder. I've built several engines but all stock. Never done any performance stuff at all.
The motor is supposed to have V8 rods (283) but I don't know for sure.
Last edited by Kerry Pinkerton; 06/14/08 10:06 PM.
