.100 below the deck,,,that is not good.
There is no quench action going on there.
Are you sure it is .100 down & not .010 seems a bit excessive??
That would mean you would need to wake off .100 off the block to get zero deck.
I believe I have those pistons you have & milled them to be flat tops w/no valve relieves.
After the milling I did , now I would have to mill the block/deck down .103 to have a zero deck.
I can look @ the PN on my pistons to see if they are the same as yours,it's been a while since I looked @ mine.
MBHD
