Tlowe,,,Tom ,
hello,,,,,,,,
me & a friend were looking @ your graph on the HP , A/F , Tq
and we noticed as your A/F ratio gets richer 3700 RPM & your HP is following the A/F ratio.
It looks like it might be getting too rich ,,or your are running out of air.
I would think the 62-1 has enough air to feed your engine, so maybe the intake windows might be too small w/your deviders you installed?
Basically , wondering if you tried to lean it out when running on the dyno?
Your HP should be much higher I would think, & torque.
It seems a tad rich,but maybe you tried to lean it out allready?
Also, on your timeing chart where is 0 vacuum,80 or 90 on the map sensor?
Full boost is 180 on the map
9 in full vacuum?
If so it looks like your timeing w/no boost ,full vacuum, 2000 RPM looks like a default settings?
I would think you need more timeing @ full vacuum or part throttle cruise, it is showing only 24 degrees total timeing under full vacuum, or am I reading this incorrectly?
MBHD
