I think the Carter & Edelbrock carbs are very simular if not the same carb, w/minor differences.
IIRC there are books out there on how to run Holly carbs for blow through application.
You need the plastic type floats,so they do not collaspe under boost pressure & other mods to be done.
I used three DCOE side draft Weber carbs,because there shafts are sealed & do not leak under boost pressure.
I believe not all Weber side draft carbs are all sealed shafts,so you need to shop for the correct one.
Higher pressure fuel pumps are not that much $$$ & if you are only going w/5 -10 psi boost pressure a Holly or other higher pressure electric pumps will work.
I used a Holley Blue pump that had a pressure of 18-20 PSI IIRC.
I only saw up to 10 psi of blower pressure.
I also used just a cheapo Holley regulator w/a boost ref line to the top of the diaphram area that was sealed off,easy set-up & low dollar.
MBHD
