This is by no means a small turbo, not stock from the Neon. The turbine wheel from this turbo is 3/4 the size of the turbine HOUSING of the turbo from a 1979 Buick.
If I am reading you correctly,,,your new turbo,,the turbine wheel,,,is smaller than a 79 Buick turbo?
You will need the turbine wheel to be approx 2.5" diameter,measure the exit hole of the turbine housing when you get a chance,,,,I still think it is going to be too small, but well see
Turbo lag will be a bigger problem w/a draw through set-up as compared to a blow throught set up.
You just need to correct sized turbine wheel & turbine housing mainly to get proper spool-up.
My Syclone has 8.4:1 compression & has minimal turbo lag.
MBHD
