Inliners International Forums General Discussion Hi Performance Help needed to change 4 piles into 1

This is something simple because as I learn more about it my whole part in this is simple. The MS guys did all the hard stuff. I've been doing a lot of searching on the MS forum. I will try to do what EFI-DIY suggested. I think there is something in the injector setup that is off. I have power in ON & START. The low impedance injectors have a special setting and I have to go back and check where I am with that. I think power to the injectors is being cut to protect them. There is a new 2" of snow and lots of wind so I'm going to do as much as I can inside today. I can do some of that with the stim board. Beater
P.S. We did a similar thing with my son's Stude. It has the same firing order as a SBC but the rotor turns the other way. It hit on #1.