CNC-Dude
I gotta say after reading these posts about aftermarket rods (especially steel) I'd stick with the Crower or Scat! It sounds like although the 292 is a big brute torque monster, it'd put a serious dent in my budget! Mighty 6 was saying to do a build similar to his it'd run around 20-25K! That's more money than I'd end up spending on the whole car! lol. I sounds like the 4200 or the 250 is a better route to go (b/c of cheaper parts and availability of aftermarket products). I wish I had the money to build both, or better yet all three
Maybe later on down the road I can build a 292, I think that motor would be bitchin' in a '67 Nova!!! I'm sure the size/fitting issues would be the major issue though. Thanks for the parts advice!
