Originally Posted By: snowman4839

I'm going to put in new:
-Head gasket Get the Felpro 1025 HG
"While your in there" \:D
Surface cyl head .040 or more.
-flwheel ,new flywheel? get a steel one, not cast iron.Use a 153 tooth one that is a bit lighter than stock. IIRC, stock flywheel weighs 32-35 lbs?[/b]


New pressure plate?
get a 3000-3200 lbs diaphram type. You are probably going to burn up the clutch more w/the new found power & the stock low lb diaphram pressure plate is pretty weak lb wise.
I know I had the standard 3 speed trans factory in my Camaro.

BTW, did you pull the cylinder head off?
If so,,, did you happen to look @ the tops of the pistons?
Post some pics of the pistons when you get a chance?Thanks

MBHD

12 port SDS EFI