Check to see if you can find that same intercooler kit minus the 90* sweeps.
Unless you are planning on cutting them to fit.
You should be able to find the exact same one with 70* bends that replace the 90*'s.

As previously stated anytime it makes a hard turn your restricting flow.

It took me a while till I found a piping package without 90*'s
This is the one I'm looking at for mine: http://www.ebay.com/itm/250842398542?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
When I purchase it I will inquire if I can swap out the 90* silicon elbows for 45* elbows.
If not I will purchase 4 extra 45* elbows.

Good luck,
Stu