No worries, truth be told, I love a good technical conversation. I haven't given up on this head 194 head yet; maybe I have a ringer!
I think I mentioned it earlier.....my buddy owns his own cylinder head shop so I may just go ahead and see if I can't talk him into a little extra effort and see what this thing flows bone stock. Then maybe modify one chamber, and retest. If improvement looks promising, then finish her up and run it, if not, well then I suppose I'll have more to think about.
Before I do any of that though I need to unwrap her and get a better look.
Off topic: I think I read from another thread where Hank had used the Balance Shop in Reseda for some of his work, well if that's the case, small world, I used him as well for an LS build back in 05.
