Originally Posted By: snowman4839
Well what's a normal amount to mill off? Because every thousandth pushes that CR closer to 9.5 which is what it would be if it was zero decked

He just answered my questions and gave me a price and told me to talk to him in a few months when I'm ready to buy

You have any links to those higher horsepower turbos?


To clean up the deck at least .002"-.005"

Tlowe could tell you how far down the deck the pistons are,, .010-.020" ? Guessing here.

Ask Tlowe also if there is room to notch the pistons a bit to lower the compression.

As far as turbo,, how much power do you want, do you still want it to boost down low or have the power/boost in in after 3000 RPM?

Forgot, @ what RPM do you see full boost currently? (When the engine was running)
Also, what RPM was it at when first seeing boost?

MBHD

12 port SDS EFI