Here is the setup I came up with to connect a motorcraft 2 barrel to the stock throttle setup. I used a 1 inch phenolic adapter plate to adapt the 2 barrel to the 4 barrel Offy manifold
I tapped a hole in the spacer for the nylon pulley and made a nice ball pivot on the throttle arm, super polished and treated with titanium disulphide for friction free movement. Just pulling down on the cable activates the throttle.
I make no promises :-)
Thanks, Vman, I like your solution for the throttle on the rear of the manifold. Mine was on the front and found another solution, not quite as clean, but it works.
Kind of hard to see, but I used existing throttle and transmission linkage, converted to cable to bring around to the front side.
Mark
