Gentlemen,
Pulled the plugs. Water on plugs 3 and 4. No water on any others and all six were "coffee brown". Cranked 'er over and water flew out of #3. Number 4 just a tad of water. # 1 near the water pump area was dry. Still runs well, but lots of steam!!
Next step is pull the head.
By the way, is there a way to tell if it's just a head gasket, or if there is a crack in the head or block, before pulling the head?
Thank you.
Ken

Last edited by El Viejo; 07/15/15 06:31 PM.