Did a dry fit of the headers, hoping to get the car to the muffler shop Tuesday. Doesn't look like I'll make it.
Header hits on the thermostat. I need to grind about 1/8" off the corner of the header.
Now comes the issue. The exhaust clamp for the original intake is intended to mount quite a ways out. The intake has an "ear", but the new headers do not have the same "ear". I just need a couple more of those short clamps, eh? I looked at a few websites, found mounting studs, but none of those little clamps. Not interested in scouring junkyards; the L6's are long gone. What did you do to cover this? Where do you find clamps?
