I had already spoken to Crower, Schneider, Isky, and Crane before I found out for sure that the six cylinder billet was the same as the four for as far as it goes. I had a good conversation with the folks a Schneider, but they didn't have a core and were uncertain of the compatibility with the six cylinder blank.
I'll be retracing my steps in the next couple of weeks. Both Comp and Isky said they could grind one from a round lobe and Comp has the hydraulic profile I'd most like to use.
My brother has an R&D connection with Comp as well. In this case I'd be calling in a favor. It might save me a buck or two if I can get it done.
Between all of us, SURELY we can come up with something!!
